Turning On The Av Receiver; Turning On And Standby - Integra DTR-7.7 Instruction Manual

Turning On the AV Receiver

Standby/On
Standby indicator

Turning On and Standby

Remote
AV receiver
controller
or
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here's a few easy steps to help you configure the AV receiver before you use it for the
very first time. These settings only need to be made once.
■ Do the automatic speaker setup—this is essential!
See "Automatic Speaker Setup" on page 38.
■ Have you connected a component to an HDMI input,
component video input, or digital audio input?
If you have, see "HDMI Video Setup" on page 41, "Component
Video Setup" on page 42, or "Digital Audio Input Setup" on page 43
respectively.
■ Have you connected an Onkyo MD recorder, CD recorder, or
next generation HDD-compatible component?
If you have, see "Changing the Input Display" on page 44.
Press the [Standby/On] button.
Alternatively, press the remote controller's [Receiver] button, followed by
the [On] button.
The AV receiver comes on, the display lights up, and the Standby indicator goes off.
Pressing the remote controller's [On] button again will turn on any components con-
nected via .
To turn the AV receiver off, press the [Standby/On] button, or press the remote control-
ler's [Standby] button. The AV receiver will enter Standby mode. To prevent any loud
surprises when you turn on the AV receiver, always turn down the volume before you
turn it off.
Standby
On
Receiver
Y
HDMI
P
B
P
R
OUT IN
CD recorder, MD recorder,
TAPE
RI Dock, etc.
COAXIAL
OPTICAL
37