Resetting The Remote Controller; Controlling Other Components - Integra DTR-50.5 Instruction Manual

Resetting the Remote Controller

You can reset the remote controller to its default
settings.
1 While holding down Receiver, press and hold
down Home until Receiver lights (about 3
seconds).
2 Within 30 seconds, press Receiver again.
Receiver flashes twice, indicating that the
remote controller has been reset.

Controlling Other Components

By pressing the Remote Mode button that's been
programmed with the remote control code for your
component, you can control your component as
described below.
For details on entering a remote control code for other
components, see "Entering Remote Control Codes"
(➔ page 82).
Controlling a TV
TV is preprogrammed with the remote control code
for controlling a TV that supports the
(limited to some models). The TV must be able to
receive remote control commands via
be connected to the AV receiver via HDMI. If
controlling your TV via doesn't work very
well, program your TV's remote control code into TV
and use the TV remote mode to control your TV.
Use the following remote control codes:
11807/13100/13500:
TV with
Controlling Apple TV
By programming the supplied remote controller with
the appropriate remote control code, you can use it to
operate your Apple TV.
Use the following remote control codes:
02615:
Apple TV
Controlling MHL-Enabled Mobile Device
By programming the supplied remote controller with
the appropriate remote control code, you can use it to
operate your MHL-enabled mobile device.
Connect your MHL-enabled mobile device to the AUX
Input MHL jack. We advise you to program the
remote control code on the AUX button.
Use the following remote control codes:
(North American models)
33101:
MHL-enabled mobile device
(Australian models)
32910:
MHL-enabled mobile device
Note
*1 • With some mobile devices, reliable operation cannot be
guaranteed.
and
Controlling a Blu-ray Disc/DVD Player, HD
DVD Player or DVD Recorder
BD/DVD is preprogrammed with the remote control
code for controlling a component that supports the
*1 (limited to some models). The component
must be able to receive remote control commands via
and be connected to the AV receiver via
HDMI.
Use the following remote control codes:
32910/33101/33501/31612:
Blu-ray Disc/DVD player with
En-84
Controlling Other Components
*1 The supported by the AV receiver is the CEC
system control function of the HDMI standard.