Multicast > Bridge Multicast; Multicast > Bridge Multicast Forward All; Snmp > Global Parameters - Linksys SRW208 User Manual

Chapter 5
Indicates the amount of time the host
Leave Timeout
waits, after requesting to leave the IGMP group and not
receiving a Join message from another station, before
timing out. If a Leave Timeout occurs, the switch notifies
the Multicast device to stop sending traffic The Leave
Timeout value is either user-defined, or an immediate
leave value. The default timeout is 10 seconds.
Multicast > Bridge Multicast
Multicast > Global Settings
The Bridge Multicast screen displays the ports and LAGs
attached to the Multicast service group in the Ports and
LAGs tables. The Port and LAG tables also reflect the
manner in which the port or LAGs joined the Multicast
group. Ports can be added either to existing groups or to
new Multicast service groups. The Bridge Multicast screen
permits new Multicast service groups to be created. The
Bridge Multicast screen also assigns ports to a specific
Multicast service address group.
The Bridge Multicast screen is divided into two areas,
Configuring Multicast and Multicast Table. The fields are
the same for both areas.
Identifies a VLAN to be configured to a Multicast
VLAN ID
service.
Bridge Multicast Address
MAC address/IP address.
DIsplays the port that can be added
Bridge IP Multicast
to a Multicast service.
Displays LAG that can be added to a Multicast
LAG
service.
The configuration options are as follows:
Indicates the
Static
8-Port 10/100 Ethernet Switch with Webview
Identifies the Multicast group
port is user-defined.
Advanced Configuration
Indicates the
Dynamic
dynamically.
Forbidden ports are not included the
Forbidden
Multicast group, even if IGMP snooping designated
the port to join a Multicast group.
The port is not configured for Multicast service.
None
The Add to List button adds the configured RMON event
to the Event Table at the bottom of the screen.
Multicast > Bridge Multicast Forward All
Multicast > Multicast Forward All
The Bridge Multicast Forward All screen contains fields
for attaching ports or LAGs to a device that is attached
to a neighboring Multicast router/switch. Once IGMP
Snooping is enabled, Multicast packets are forwarded to
the appropriate port or VLAN.
The Bridge Multicast Forward All screen contains the
following fields:
DIsplays the VLAN for which Multicast
VLAN ID
parameters are displayed.
The configuration options are as follows:
The port is not configured for Multicast service.
None
Forbidden ports are not included the
Forbidden
Multicast group, even if IGMP snooping designated
the port to join a Multicast group.
Indicates the port is user-defined.
Static
Indicates the
Dynamic
dynamically.
SNMP > Global Parameters
The Global Parameters screen contains parameters for
defining SNMP notification parameters.
port is configured
port is configured
47