Cos Default; Qos > Queue Settings; Qos > Dscp Settings; Qos > Bandwidth - Linksys SRW208 User Manual

Chapter 5
Enables QoS on the interface.
Basic
Enables Advanced mode QoS on the
Advanced
interface.
Specifies the CoS priority tag values,
Class of Service
where zero is the lowest and 7 is the highest.
Defines the traffic forwarding queue to which the
Queue
CoS priority is mapped. Four traffic priority queues are
supported.
The Restore Defaults button restores the device factory
defaults for mapping CoS values to a forwarding queue.

CoS Default

Interface to which the CoS configuration
Interface
applies.
Determines the default CoS value for
Default CoS
incoming packets for which a VLAN tag is not defined. The
possible field values are 0-7. The default CoS is 0.
Restores the device factory defaults for
Restore Defaults
mapping CoS values to a forwarding queue.
LAG to which the CoS configuration applies.
LAG
QoS > Queue Settings
QoS > Queue Settings
The Queue Setting screen contains fields for defining the
QoS queue forwarding types.
Indicates that traffic scheduling for the
Strict Priority
selected queue is based strictly on the queue priority.
Indicates that traffic scheduling for the selected
WRR
queue is based strictly on the WRR.
Displays the queue for which the queue settings
Queue
are displayed. The possible field range is 1 - 4.
Displays the WRR weights to queues.
WRR Weight
8-Port 10/100 Ethernet Switch with Webview
Advanced Configuration
Displays the amount of bandwidth
% of WRR Bandwidth
assigned to the queue. These values are fixed and are not
user defined.
QoS > DSCP Settings
QoS > DSCP Settings
The DSCP Settings screen enables mapping DSCP values to
specific queues.
The DSCP Settings screen contains the following fields:
Indicates the Differentiated Services Code Point
DSCP
value in the incoming packet.
Maps the DSCP value to the selected queue.
Queue
QoS > Bandwidth
QoS > Bandwidth
The Bandwidth screen allows network managers to define
the bandwidth settings for a specified egress interface.
38