Srw208L - Front Panel; Srw208P/Srw208Mp - Front Panel - Linksys SRW208 User Manual

Chapter 2
The Console port is where you can
Console
connect a serial cable to a PC's serial port for
configuration using your PC's HyperTerminal
program. Refer to Chapter 4: Using the
Console Interface for Configuration for more
information.

SRW208L - Front Panel

The LEDs and ports are located on the front panel of the
Switch.
Front Panel
(Green) The system LED lights up to
SYSTEM
indicate that the Switch is powered on.
(Green) The LINK/ACT LED lights up
LINK/ACT
to indicate a functional network link through the
corresponding port (1 through 8, G1, or 100LX)
with an attached device. It flashes to indicate
that the Switch is actively sending or receiving
data over that port.
(Orange) The 100M LED lights up
100M
to indicate a 100Mbps connection on the
corresponding port (1 through 8).
(Orange) The Gigabit LED lights
Gigabit
up to indicate a Gigabit connection on the
corresponding RJ-45 port (G1) or miniGBIC port
(G2).
The Switch is equipped
ETHERNET 1-8
with 8 auto-sensing, Ethernet network ports,
which use RJ-45 connectors. The Fast Ethernet
ports support network speeds of 10Mbps or
100Mbps.
They can operate in half and full-duplex modes.
Auto-sensing technology enables each port to
automatically detect the speed of the device
connected to it (10Mbps or 100Mbps), and
adjust its speed and duplex accordingly.
8-Port 10/100 Ethernet Switch with Webview
The mini-GBIC (gigabit interface converter)
G1
port is a connection point for a mini-GBIC
expansion module, so the Switch can be
uplinked via fiber to another switch. Each
MiniGBIC port provides a link to a high-speed
network segment or individual workstation at
speeds of up to 1000Mbps.
Use the Linksys MGBT1, MGBSX1, or MGBLH1
mini-GBIC modules with the Switch. The
MGBSX1 and the MGBLH1 require fiber cabling
with LC connectors, while the MGBT1 requires
a Category 5e Ethernet cable with an RJ-45
connector.
The 100LX port is where you can connect
9
The Console port is where you can
Console
connect a serial cable to a PC's serial port for
configuration using your PC's HyperTerminal
program. Refer to Chapter 4: Using the
Console Interface for Configuration for more
information.

SRW208P/SRW208MP - Front Panel

The LEDs and ports are located on the front panel of the
Switch.
Front Panel
(Green) The system LED lights up to
SYSTEM
indicate that the Switch is powered on.
(Green) The LINK/ACT LED
LINK/ACT (1-8)
lights up to indicate a functional network link
through the corresponding port (1 through 8)
with an attached device. It flashes to indicate
that the Switch is actively sending or receiving
data over that port.
(Orange) The PoE LED lights up to indicate
PoE
a device is connected utilizing Power over
Ethernet on the corresponding port (1 through
8).
Product Overview
3