Port Coniguration Detail - Linksys SRW208 User Manual

Chapter 5
The connection speed of the port is displayed here.
Speed
The speed can be configured only when auto-negotiation
is disabled on that port.
Port Management > Port Settings
This is the port duplex mode, Full (transmission
Duplex
occurs in both directions simultaneously) or Half
(transmission occurs in only one direction at a time). This
mode can be configured only when auto-negotiation is
disabled and port speed is set to 10Mbps or 100Mbps.
It cannot be configured on Link Aggregation Groups
(LAGs).
This is the MDI/MDIX status of the port. The
MDI/MIDX
MDI setting is used if the port is connected to an end
station. The MDIX setting is used if the port is connected
to a hub or another switch.
This is the flow control status of the port. It
Flow Control
is active when the port uses Full Duplex Mode.
This indicates if the port is part of a LAG.
LAG
Displays the port type.
Type
When a port is a Private VLAN Edge (PVE) port,
PVE
it bypasses the Forwarding Database and forwards all
unicast, multicast, and broadcast traffic to an uplink.
Uplinks can be ports or LAGs.
The Detail button will open the Port Configuration
Detail
Detail screen.
8-Port 10/100 Ethernet Switch with Webview
Advanced Configuration
Port Configuration Detail
Port Management > Port Configuration
The number of the port.
Port
Displays a brief description of the port (can
Description
be entered by clicking on the Detail button).
This is the port type.
Port Type
The port can be taken offline by selecting
Admin Status
the Down option. When Up is selected, the port can be
accessed normally.
The current status of the port is
Current Port Status
displayed here.
Reactivate Suspended Port
port that has been suspended, click the checkbox.
This indicates whether or not the
Operational Status
port is active.
Change the speed of the port here.
Admin Speed
The current speed of the port is
Current Port Speed
displayed here.
Change the duplex mode here.
Admin Duplex
This is the duplex mode of the
Current Duplex Mode
port.
You can enable or disable the port's
Auto Negotiation
Auto Negotiation feature. If using an SFP module, Auto
Negotiation for the specific port should be set to Disable.
Current Auto Negotiation
the port's Auto Negotiation feature.
Specifies the capabilities to be
Admin Advertisement
advertised by the port. Multiple options may be selected
or Max Capability can be selected to cover all of the
options. The available options are:
If you want to reactivate a
This is the current setting of
21