Vlan Management > Create Vlan; Single Vlan; Vlan Range; Vlan Table - Linksys SRW208 User Manual

Chapter 5
Indicates whether PoE is enabled or
Admin Status
disabled on the port.
Indicates the PoE priority setting of the port. The
Priority
possible values are: Critical, High and Low. The default is
Low.
Power Allocation (milliwatts)
amount of power the device can supply.
Indicates whether the port is enabled to utilize
Mode
PoE.
Power Consumption (milliwatts)
of the power used by the device.
The Modify PoE Page displays the
NOTE:
currently configured PoE ports. This option is
only seen on the SRW208P and SRW208MP.
VLAN Management > Create VLAN
The Create VLAN screen provides information and global
parameters for configuring and working with VLANs.
VLAN Management > Create VLAN

Single VLAN

Indicates the ID number of the VLAN
VLAN ID (2-4094)
being configured. Up to 256 VLANs can be created. This
field is used to add VLANs one at a time. To add the defined
VLAN ID number, press the Add button.
Displays the user-defined VLAN name.
VLAN Name

VLAN Range

VLAN Range. Indicates a range of VLANs being configured.
To add the defined range of VLAN ID numbers, press the
Add Range button.
8-Port 10/100 Ethernet Switch with Webview
Indicates the actual
Indicates the amount
Advanced Configuration

VLAN Table

The VLAN Table displays a list of all configured VLANs. The
VLAN ID, VLAN Name, and status of the VLAN are displayed
here. To remove a VLAN, click the Remove button.
VLAN Management > Port Settings
VLAN Management > Port Settings
The VLAN Port Settings screen provides parameters for
managing ports that are part of a VLAN. The port default
VLAN ID (PVID) is configured on the VLAN Port Settings
screen. All untagged packets arriving to the device are
tagged by the ports PVID.
The port number included in the VLAN:
Port
Indicates the port mode. Possible values are:
Mode
The port belongs to VLANs, and each VLAN
General
is user-defined as tagged or untagged (full 802.1Q
mode).
The port belongs to a single untagged VLAN.
Access
When a port is in Access mode, the packet types which
are accepted on the port (packet type) cannot be
designated. It is also not possible to enable/disable
ingress filtering on an access port.
The port belongs to VLANs in which all ports are
Trunk
tagged (except for an optional single native VLAN).
Packet type accepted on the
Acceptable Frame Type
port. Possible values are:
Indicates that only tagged packets
Admit Tag Only
are accepted on the port.
Indicates that both tagged and untagged
Admit All
packets are accepted on the port.
24