System Information; Poe Information; Setup > Network Settings; Identiication - Linksys SRW208 User Manual

Chapter 5
Indicates whether the Switch is configured
Address Mode
with a Static or Dynamic IP address (configurable from
Setup - Network Settings tab).
This is the MAC address of the
Base MAC Address
Switch.

System Information

The serial number of the Switch is
Serial Number
displayed.
The model name of the Switch is
Model Name
displayed.
The current hardware version is
Hardware version
displayed.
The current boot version is displayed.
Boot Version
The current software version is
Firmware Version
displayed.
The system location is displayed here
System Location
(configurable from Setup > Network Settings tab).
The contact person for this Switch
System Contact
is displayed here (configurable from Setup > Network
Settings tab).
This displays the amount of time that
System Uptime
has elapsed since the Switch was last reset.
The system time is displayed here
Current Time
(configurable from Setup > Time tab).

PoE Information

Maximum Available Power
amount of power the device can supply.
System Operation Status
function is on or off.
Mainpower Consumption
currently used.
8-Port 10/100 Ethernet Switch with Webview
Indicates the maximum
Indicates whether the PoE
Displays how much power is
Advanced Configuration
Setup > Network Settings
Setup > Network Settings
The Network Settings screen allows you to assign DHCP
or static IP settings to interfaces and assign default
gateways.
Identification
This field allows you to assign a system
System Name
name.
This field is used for entering a
System Location
description of where the Switch is located, such as 3rd
floor.
Enter the administrative contact person
System Contact
in this field.
The system object identifier is
System Object ID
displayed here.
This is the MAC address of the
Base MAC Address
Switch.
IP Configuration
This drop-down allows you to select
Management VLAN
the Management VLAN.
This drop-down allows you to select
IP Address Mode
Static or Dynamic IP address configuration.
Enter the DHCP Host Name here.
Host Name
If using a static IP address, enter the IP address
IP Address
here.
Enter the subnet mask of the currently
Subnet Mask
configured IP address.
Enter the IP address of the Default
Default Gateway
Gateway.
19