Multicast Tab - Global Settings - Linksys MGBLH1 - Gigabit LH Mini-GBIC SFP Transceiver User Manual

Using the web-based Utility for Configuration

Multicast Tab - Global Settings

Range—Ethernet: 200,000-20,000,000
Fast Ethernet—20,000-2,000,000
Gigabit Ethernet—2,000-200,000
Default—Ethernet – Half duplex: 2,000,000; full duplex: 1,000,000; LAG: 500,000
Fast Ethernet—Half duplex: 200,000; full duplex: 100,000; LAG: 50,000
Gigabit Ethernet—Full duplex: 10,000; LAG: 5,000
Interface Priority—Defines the priority used for this port in the Spanning Tree Protocol. If the
path cost for all ports on a switch are the same, the port with the highest priority (i.e., lowest
value) will be configured as an active link in the Spanning Tree. This makes a port with higher
priority less likely to be blocked if the Spanning Tree Protocol is detecting network loops.
Where more than one port is assigned the highest priority, the port with lowest numeric
identifier will be enabled. (Range: 0-240, in steps of 16; Default: 128)
Multicast Tab - Global Settings
You can configure the switch to forward multicast traffic intelligently. Based on the IGMP query
and report messages, the switch forwards traffic only to the ports that request multicast traffic.
SRW2024P User Guide 95