Linksys MFEFX1 User Manual

100base-fx minigbic sfp transceiver, 100base-lx minigbic sfp transceiver
Hide thumbs Also See for MFEFX1:

Advertisement

Quick Links

USER GUIDE
100BASE-FX MiniGBIC
BUSINESS SERIES
SFP Transceiver,
100BASE-LX MiniGBIC
SFP Transceiver
MFEFX1, MFELX1
Model:

Advertisement

Table of Contents
loading

Summary of Contents for Linksys MFEFX1

  • Page 1 USER GUIDE 100BASE-FX MiniGBIC BUSINESS SERIES SFP Transceiver, 100BASE-LX MiniGBIC SFP Transceiver MFEFX1, MFELX1 Model:...
  • Page 3: Table Of Contents

    Need to contact Linksys? . . . . . . . . . . . . . . . . . .
  • Page 4: Chapter 1: Connect The Transceiver

    Connect the Transcever Introduction Thank you for choosing the MiniGBIC SFP Modules . These Modules insert into the MiniGBIC ports on Linksys switches . Each MiniGBIC SFP Module is hot-swappable, meaning you can connect them even when the switch is running .
  • Page 5 Remove the MiniGBIC SFP Module’s rubber port cap . Connect the fiber cable’s LC Connector to the MiniGBIC SFP Module’s port . MnGBIC SFP Transcevers Connect the Transceiver Remove the Rubber Port Cap Connect the Fiber Cable...
  • Page 6: Removal Instructions

    Chapter 1 Connect the other end of the cable to an SFP Module to verify that the fiber connection is complete . Removal Instructions Press the fiber cable’s connector and pull to remove the fiber cable from the MiniGBIC SFP Module . Connected Fiber Cable Remove the Fiber Cable MnGBIC SFP Transcevers...
  • Page 7 To remove the MiniGBIC SFP Module, begin by pulling the Module’s bail latch down . Remove the MiniGBIC SFP Module . MnGBIC SFP Transcevers Connect the Transceiver Pull the Bail Latch Down Remove the Module...
  • Page 8: Appendix A: Specifications

    Appendx A Appendx A: Specfcatons MFEFX1 Standards Connector Type Wavelength Typical (Tx) Wavelength Range (Tx) Wavelength Range (Rx) Performance Average Output Power Extinction Ratio (Tx) Receiver Sensitivity Receiver Overload Envronmental Dimensions H x W x D Weight Power Certification Operating Temp .
  • Page 9: Mfelx1

    MFELX1 Standards Connector Type Wavelength Typical (Tx) Wavelength Range (Tx) Wavelength Range (Rx) Performance Average Output Power Extinction Ratio (Tx) Receiver Sensitivity Receiver Overload Envronmental Dimensions H x W x D Weight Power Certification Operating Temp . Storage Temp . Operating Humidity Storage Humidity MnGBIC SFP Transcevers...
  • Page 10: Appendix B: Switch Compatibility List

    Appendx B Appendx B: Swtch Compatblty Lst Linksys 100M SFP Switch Support and Minimum Software Release Requirements Swtch Model SRW208G SRW208L SRW208P SRW208MP SRW2008 SRW2008P SRW2008MP SRW224G4 SRW248G4 SRW224G4P SRW248G4P SRW2024P SRW2016 SRW2024 SRW2048 MFEFX1 - 100 SFP Firmware 1 .0 .3 Firmware 1 .0 .3...
  • Page 11: Appendix C: Warranty And Regulatory Information

    Warranty and Regulatory Informaton Limited Warranty Linksys warrants to You that, for a period of one year (the “Warranty Period”), your Linksys Product will be substantially free of defects in materials and workmanship under normal use . Your exclusive remedy and Linksys’...
  • Page 12 Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to You . Please direct all inquiries to: Linksys, P .O . Box 18558, Irvine, CA 92623 . MnGBIC SFP Transcevers...
  • Page 13: Fcc Statement

    FCC Statement This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules . These limits are designed to provide reasonable protection against harmful interference in a residential installation . This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications .
  • Page 14: Industry Canada (Canada)

    Appendx C Industry Canada (Canada) This device complies with Industry Canada ICES-003 rule . Cet appareil est conforme à la norme NMB003 d’Industrie Canada . IC Statement Operation is subject to the following two conditions: This device may not cause interference and This device must accept any interference, including interference that may cause undesired operation of the device .
  • Page 15 2002/96/EC on Waste Electric and Electronic Equipment (WEEE) This document contains important information for users with regards to the proper disposal and recycling of Linksys products . Consumers are required to comply with this notice for all electronic products bearing...
  • Page 16 Appendx C Dansk (Dansh) - Mljønformaton for kunder  EU EU-direktiv 2002/96/EF kræver, at udstyr der bærer dette symbol på produktet og/eller emballagen ikke må bortskaffes som usorteret kommunalt affald . Symbolet betyder, at dette produkt skal bortskaffes adskilt fra det almindelige husholdningsaffald . Det er dit ansvar at bortskaffe dette og andet elektrisk og elektronisk udstyr via bestemte indsamlingssteder udpeget af staten eller de lokale myndigheder .
  • Page 17 Warranty and Regulation Information Español (Spansh) - Informacón medoambental para clentes de la Unón Europea La Directiva 2002/96/CE de la UE exige que los equipos que lleven este símbolo en el propio aparato y/o en su embalaje no deben eliminarse junto con otros residuos urbanos no seleccionados .
  • Page 18 Appendx C Italano (Italan) - Informazon relatve all’ambente per  clent resdent nell’Unone Europea La direttiva europea 2002/96/EC richiede che le apparecchiature contrassegnate con questo simbolo sul prodotto e/o sull’imballaggio non siano smaltite insieme ai rifiuti urbani non differenziati . Il simbolo indica che questo prodotto non deve essere smaltito insieme ai normali rifiuti domestici .
  • Page 19 Warranty and Regulation Information Malt (Maltese) - Informazzjon Ambjental għal Kljent fl-Unjon Ewropea Id-Direttiva Ewropea 2002/96/KE titlob li t-tagħmir li jkun fih is-simbolu fuq il-prodott u/jew fuq l-ippakkjar ma jistax jintrema ma’ skart muniċipali li ma ġiex isseparat . Is-simbolu jindika li dan il-prodott għandu jintrema separatament minn ma’...
  • Page 20 Appendx C Norsk (Norwegan) - Mljønformasjon for kunder  EU EU-direktiv 2002/96/EF krever at utstyr med følgende symbol avbildet på produktet og/ eller pakningen, ikke må kastes sammen med usortert avfall . Symbolet indikerer at dette produktet skal håndteres atskilt fra ordinær avfallsinnsamling for husholdningsavfall . Det er ditt ansvar å...
  • Page 21 Warranty and Regulation Information Slovenčna (Slovak) - Informáce o ochrane žvotného prostreda pre zákazníkov v Európskej ún Podľa európskej smernice 2002/96/ES zariadenie s týmto symbolom na produkte a/alebo jeho balení nesmie byť likvidované spolu s netriedeným komunálnym odpadom . Symbol znamená, že produkt by sa mal likvidovať...
  • Page 22 Appendx C Svenska (Swedsh) - Mljönformaton för kunder  Europeska unonen Det europeiska direktivet 2002/96/EC kräver att utrustning med denna symbol produkten och/eller förpackningen inte får kastas med osorterat kommunalt avfall . Symbolen visar att denna produkt bör kastas efter att den avskiljts från vanligt hushållsavfall . Det faller på...
  • Page 23: Appendix D: Contact Information

    Or fax your request in to: If you experience problems with any Linksys product, you can call us at: Don’t wish to call? You can e-mail us at: If any Linksys product proves defective during its warranty period, you can...

This manual is also suitable for:

Mfelx1Srw208p - cisco small business managed switch

Table of Contents