Items Relating To The Video Control (Nos. 706 To - Sony SRW-5800 Operation Manual

Item number Item
628 REMAIN TIME
DISPLAY
629 CONDITION
DISPLAY VIDEO
MONITOR
630 TC CONVERT
631 ORIGINAL TC
display
632 JUMPING TC
select
633 CHARA ORG TC
DISPLAY at dual
line mode

Items Relating to the Video Control (Nos. 706 to ...)

Item number Item
706 FORCED
VERTICAL
INTERPOLATION
OFF
Setting Function
[off] Sets whether to display remaining time on the tape in
10min superimposed character position.
on off: Do not display remaining time.
10min: Display remaining time when it is 10 minutes or
on: Always display remaining time.
Note
The remaining time on the tape is not displayed when no
cassette is inserted. The remaining time is not also
displayed until the VTR finishes detecting the diameter of
the wound tape and estimating the remaining time
immediately after the cassette is inserted.
enable Sets whether or not to display playback signal status in
[disable]
superimposed character position.
enable: Displays playback signal status.
disable: Does not display playback signal status.
[off]
Selects whether to convert the playback time code to the
on operating frequency time code when tapes recorded with
different frame rates are used for off-speed playback.
off: Does not convert the time code.
on: Converts the time code.
[off] When item 630 is set to "on," this setting specifies whether
on the 24-frame time code is displayed or not on the control
panel of the VTR before conversion.
off: The 24-frame time code is not displayed before
on: The 24-frame time code is displayed before conversion.
Sets the loopback point (JUMPING TC) for converting time
code with respect to the reference time code (STARTING
–2H
TC) for conversion.
–1H
–3H: The JUMPING TC is set 3 hours before STARTING
+1H
+2H
–2H: The JUMPING TC is set 2 hours before STARTING
+3H
0H
–1H: The JUMPING TC is set 1 hour before STARTING TC.
+1H: The JUMPING TC is set 1 hour after STARTING TC.
+2H: The JUMPING TC is set 2 hours after STARTING TC.
+3H: The JUMPING TC is set 3 hours after STARTING TC.
0H: The JUMPING TC is set 1 frame before STARTING TC.
[off] Selects whether to display the time code of the playback
on tape (original time code) in addition to the converted time
code, when time code has been converted and menu item
626 is set to anything other than "time data only".
off: The original time code is not displayed.
on: The original time code is displayed.
The original time code appears in the second line when you
set this item set to "on".
Setting Function
[auto] Specifies whether or not Y-add operation mode is
forced YADD off automatically turned on during DT playback.
auto: Y-add operation mode is automatically turned on.
forced YADD off: Y-add operation mode is off all the time.
less.
conversion.
The type of time code displayed is specified by item
603.
TC.
TC.
151
Menu List