Sony SRW-5800 Operation Manual page 143

Item number Item
303 POSTROLL TIME
304 VAR SPEED RANGE
FOR
SYNCHRONIZATION
305 EDIT FIELD select
306 SYNCHRONIZE
311 EDIT PRESET
REPLACE MODE
SELECT
Setting Function
0 sec This sets the tape running time after passing the OUT point
(postroll time) in automatic editing.
The range is from 0 to 30 seconds, in steps of 1 second.
[5 sec]
30 sec
[narrow]
Specifies the variable tape speed range when the variable
wide speed playback is executed by a remote control unit
connected to the REMOTE 1-IN(9P) connector.
narrow: –0.5 to +1 times normal tape speed (HDCAM-SR),
wide: –1 to +2 times normal tape speed (HDCAM-SR), –
Notes
• When this item is set to "narrow", variable speed
• When an editing control unit such as BVE-9100 is
[1F]
Selects the start timing for editing when performing tape
2F editing.
1F/2F 1F: Start editing from field 1 and end on field 2.
2F: Start editing from field 2 and end on field 1.
1F/2F: Following received timing commands.
Note
When the system frequency of this unit is PsF mode, the
unit always operates with the 1F setting.
[accurate]
When this unit is used as a controller for editing control of
rough another VTR connected through a 9-pin remote cable, this
off selects whether or not to carry out phase synchronization
of the two VTRs, and also the editing accuracy when
carrying out synchronization.
accurate: Editing is carried out with an accuracy of ±0
rough: Editing is carried out with an accuracy of ±1 frame.
off: Synchronization is not carried out.
[normal]
normal: Assigns edit preset command channels 1 to 8, to
parallel
reverse parallel: Assigns edit preset command channels 1 to 4, to
stereo
reverse: Assigns edit preset command channels 1 to 4 to
stereo: Assigns edit preset command channels 1 to 4 to
–1 to +2 times normal tape speed (HDCAM), or –1 to
+3 times normal tape speed (Digital Betacam).
1.15 to +2.45 times normal tape speed (HDCAM), or –
1.15 to +3.45 times normal tape speed (Digital
Betacam).
playback is possible within the range of speed specified
for the respective formats.
connected for DT editing, select "wide".
frames.
track channels 1 to 8.
channel pairs 1/5 to 4/8.
channels 5 to 8, and channels 5 to 8 to channels 1 to 4.
track channel pairs 1/2 to 7/8.
143
Menu List