Warning Messages - Sony SRW-5800 Operation Manual

Item number Display
12 TAPE TOP SENSOR TROUBLE
13 TAPE END SENSOR TROUBLE
14 FAN MOTOR TROUBLE
20 CASSETTE COMPARTMENT
MOTOR LOCK
21 REEL SHIFT MOTOR LOCK
22 REEL POSITION SENSOR
TROUBLE
23 THREADING RING POSITION
ERROR
24 DT HARD ERROR
26 POWER SUPPLY UNIT TROUBLE
93 DR INTERFACE ERROR
97 NVRAM CHECK SUM ERROR
FF SV UNDEFINED ERROR
A0 SYS UNDEFINED ERROR
A2 SYS1 - SYS2 DP-RAM ERROR
A5 SYS - FC DP-RAM ERROR
A8 SYS NV-RAM CHECK SUM ERROR
B8 SYS1 - SYS2 INTERFACE ERROR
B9 SYS - SV INTERFACE ERROR
BA SYS - EQ INTERFACE ERROR
BB SYS - FC INTERFACE ERROR
BC SYS - 50PIN INTERFACE ERROR

Warning Messages

When one of the problems described below is detected, a
warning mark is displayed in the upper left corner of the
display. Operation can continue even when the mark is
flashing.
If you press the SFT button (see page 18) and the DIAG
button (see page 16) when the mark is flashing, an
information display appears, showing a warning message.
Note
The warning messages can be viewed in any menu except
the CUE or SET UP menu.
128
Error Messages and Warning Messages
Meaning
A tape beginning sensor fault was detected.
A tape end sensor fault was detected.
A cooling fan motor operation fault was detected.
A fault was detected in a cassette compartment raising or lowering
operation.
A fault was detected movement of the reel table to adjust for
cassette size.
The reel table was detected in the L cassette position and S
cassette position at the same time.
The threading end and unthreading end were detected at the same
time.
A fault was detected in DT mechanism.
A fault was detected in the power supply unit.
A communications error between the SV CPU (board SS-102) and
drum CPU (board DR-508) was detected.
An operation fault was detected in the servo system NV-RAM
(board DR-508).
Undefined SV error was detected.
Undefined SY error was detected.
A DPRAM (board SS-102) operation fault between SYS1 and
SYS2 was detected.
A DPRAM (board FC-91) operation fault between SYS1 and FC
was detected.
A SYS NVRAM (board SS-102) operation fault was detected.
A SYS CPU communications fault was detected.
An SV CPU communications fault was detected.
An EQ CPU communications fault was detected.
An FC CPU communications fault was detected.
A communications fault with the 50-pin CPU was detected.
Only one message will be displayed even if there are
multiple messages. The number of errors appears at the
lower right, and you can check the messages using the R
and r buttons.
A history of errors is kept in the error log menu.
For more information about warning messages, refer to
the Maintenance Manual.
Use the displayed warning information to eliminate the
cause of the warning.
For more information about eliminating the cause of
warning, refer to the Maintenance Manual.
To automatically display a warning message
Whenever a warning occurs, change the setting of the VTR
SETUP menu item 120 "WARNING DISPLAY" to "on".