Status Display; Display Transition - Mitsubishi Electric Melservo MR-J3-A Instruction Manual

6. DISPLAY AND OPERATION SECTIONS

6.3 Status display

The servo status during operation is shown on the 5-digit, 7-segment LED display. Press the "UP" or "DOWN"
button to change display data as desired. When the required data is selected, the corresponding symbol
appears. Press the "SET" button to display its data. At only power-on, however, data appears after the symbol
of the status display selected in parameter No. PC36 has been shown for 2[s].
The servo amplifier display shows the lower five digits of 16 data items such as the motor speed.

6.3.1 Display transition

After choosing the status display mode with the "MODE" button, pressing the "UP" or "DOWN" button changes
the display as shown below.
To Bus voltage
Cumulative feedback
pulse
Servo motor speed
Droop pulse
Cumulative command
pulse
UP
Command pulse
frequency
Analog speed command
voltage
Analog speed limit voltage
Analog torque command
voltage
Analog torque limit voltage
Regenerative load ratio
DOWN
To Cumulative feedback pulse
6 - 3
Effective load ratio
Peak load ratio
Instantaneous torque
Within one-revolution position
(1 pulse unit)
Within one-revolution position
(100 pulse unit)
ABS counter
Load inertia moment ratio
Bus voltage