Staple Repositioning For The Saddle Stitcher Unit - Canon imageRunner 6020 Reference Manual Reference Manual

2
Press [–] or [+] to adjust the percentage (%) © press [OK].
The adjustment range for both the X (left-right direction) and the Y (up-down
direction) is from –1.0% to +1.0% in 0.1% increments.
The selected mode is set.
3
Press [Done] repeatedly until the Basic Features screen
appears.

Staple Repositioning for the Saddle Stitcher Unit

After a staple jam in the optional Saddle Stitcher Unit has been cleared, or the
staple cartridge is replaced, paper is fed to the unit and is stapled a few times. This
procedure makes staples immediately available for the next job.
IMPORTANT
•
This function can only be set when the Saddle Finisher-F2 (optional) is attached.
•
The following paper sizes can be used for this function: 11" x 17" or LTRR.
NOTE
•
The required paper is fed from the paper source automatically.
•
Before you perform staple repositioning, remove all of the paper in the booklet tray.
Adjusting the Machine (Adjustment/Cleaning)
3
3-61