Replacing The Staple Cartridge In The Saddle Stitcher Unit (Booklet Finisher-K1) - Canon imageRUNNER ADVANCE C9270 PRO Basic Operation Manual

Replacing the Staple Cartridge in the Saddle Stitcher Unit
(Booklet Finisher-K1)
When the saddle stitcher unit of the Booklet Finisher-K1 is almost out of staples and the staple cartridge in the saddle stitcher
unit must be replaced, a screen prompting you to replace the staple cartridge appears on the touch panel display. Follow the
procedure described below to replace the staple cartridge.
• Take care when handling the optional equipment that is attached to the machine. When an optional unit's cover is opened to
replace a staple cartridge, discard the punch waste/trim waste/staple waste, or clear paper or staple jams, prints may still be
output if other optional units are operating normally, and are not involved in the paper or staple jam removal procedure.
• If necessary, remove all of the output paper in the Booklet Tray before replacing the staple cartridge in the saddle stitcher unit.
• This procedure is necessary only if the Booklet Finisher-K1 is attached (the Booklet Finisher-K1 is an optional product).
• When replacing the staple cartridges, replace both the front and back staple cartridges.
• We recommend that you order staple cartridges from your local authorized Canon dealer before your stock runs out.
• Use only staple cartridges intended for use with this machine.
Open the front cover of the fi nisher.
1
110