Power-Up Configuration - Genie M640 User Manual

Read Only Parameters
Parameter
Device Vendor
Device Model Name
Device Version
Firmware Version
Device ID
MAC Address
User Set Parameters
Parameter
Device User ID

Power-up Configuration

Power-up Configuration
The Power-up configuration dialog allows you to specify the camera configuration to load when powering-up the
camera. The Genie camera flash memory contains two possible configuration settings; the Factory Default (neutral
parameters and in free run mode), and a user-defined Camera Configuration 1. The Camera Power-up
configuration drop-down list box allows you to select either the Factory Default or a user specified camera
configuration file. To save the current CamExpert settings to the camera user-defined (Camera Configuration)
setting, click Save. To view in CamExpert a camera configuration file currently saved in the camera, select the
configuration file in the Load configuration from Camera drop-down list, and click Load. See the parameter list
below.
32 • Operational Reference
Description
For the Genie Monochrome series, this is always DALSA.
Displays the device model name (for example, Genie M640).
Displays the device version.
Displays the currently loaded firmware version.
Displays the camera serial number.
Displays the unique MAC (Media Access Control) address of the Genie camera.
Description
Specifies a user written ID, of up to 15 characters, for the Genie camera.
By default, this field is set to the serial number of the camera.
Click Setting to open the Power-up configuration dialog box which allows you to specify
camera power-up configuration. For more information, see "Power-up
32.
Configuration" on page
Genie Monochrome Series-GigE Vision Camera