Rj45 Lan Ethernet Connector Details; Camera Status Led - Genie M640 User Manual

RJ45 LAN Ethernet Connector Details

The RJ45 LAN connector has two LEDs for network status conditions.
The LED color codes are as follows.
Network Connection
Green 100Mbps
Orange 1000Mbps
The Genie LAN connector is a standard Ethernet socket. Use CAT5e or CAT6 certified Ethernet cables. CAT5e
cable is rated for 100 MHz spectral bandwidth but CAT6 cable is rated for a 200 MHz spectral bandwidth with less
signal attenuation, therefore strongly recommended for long connection lengths.
The interconnection Ethernet cable can be either Straight Through or Crossover cable type. The Gigabit Ethernet
standard for devices defines that they will auto-negotiate send and receive channels, eliminating the need for users
to use a specific Ethernet cable type.

Camera Status LED

The Genie has one multicolor LED to provide a simple visible indication of the operational status of the camera.
When more than one condition is active, the LED color indicates the condition with the highest priority. The
following table summarizes the LED states and corresponding camera status.
LED State
LED is off
Steady Red
Slow Flashing Red
Fast Flashing Red
Slow Flashing Blue
Fast Flashing Blue
Steady Blue
Steady Green
Slow Flashing Green
Fast Flashing Green
100 • Technical Specifications
Network Activity
Off
Yellow
Network Connection
Definition
No power to the camera
Camera not initialized
Camera initialization problem
Camera is too hot
Waiting for an IP address
Ethernet cable disconnected (no link)
IP address assigned; no application connected to the camera
Application connected
Triggered acquisition in progress
Free running acquisition in progress
no network activity
typically blinking – active
Network Activity
Genie Monochrome Series-GigE Vision Camera