Related Manuals for Genie PWIP4BVAF
Summary of Contents for Genie PWIP4BVAF
- Page 1 4MP H.265 IP IR Bullet Camera with 2.8-12mm Auto Focus Lens PWIP4BVAF | PWIP4BVAFG Quick Start Guide Please read these instructions carefully before operating the unit and keep for further reference.
- Page 2 Intro Section Please read this instruction carefully before operating the product and keep it for further reference. All examples and pictures used here are for reference only. The contents of this manual are subject to change without notice. CAUTION: • If the product does not work properly, please contact your dealer or the nearest service centre.
-
Page 3: Table Of Contents
Contents 1.0 Introduction ......................4 1.1 Product Features ...................4 1.2 Product Dimensions ..................4 1.3 Contents ......................4 1.4 Specification ....................5 2.0 Overview ......................6 3.0 Installation ......................7 4.0 Network Connection ...................8... -
Page 4: Introduction
1.0 Introduction The Genie PWIP4BVAF and PWIP4BVAFG are 4MP IP IR bullet cameras with a 2.8-12mm varifocal auto focus lens. The cameras also feature up to 50m IR night view distance as well as being IP67. 1.1 Product Features •... -
Page 5: Specification
Quick Start Guide 4MP H.265 IP IR Bullet Camera with 2.8-12mm Auto Focus Lens 1.4 Specification Image Sensor 1 / 2.7 “CMOS Image Size 2560 x 1440 Electronic Shutter 1 / 25 s ~ 1 / 100000 s Iris Type Fixed Iris 0.011 Lux @ F1.2, AGC ON, 0 Lux with IR Minimum Illumination... -
Page 6: Overview
2.0 Overview Fixed Ring 2. Mounting Base 3. Network Connector 4. Power Connector 5. Micro SD Card Slot 6. Reset Focus 8. Zoom Security Cap DC12V • It is recommended to install the security cap for outdoor installation. • If the PoE switch is used to power the camera, DC12V power supply is not required. Connecting Network Cable Loosen the nut from the main element. -
Page 7: Installation
3.0 Installation Please make sure that the wall or ceiling is strong enough to withstand 3 times the weight of the camera. Please install the camera in and under a dry environment. Drill the screw holes and the cable hole on the wall according to the drill template. 2. -
Page 8: Network Connection
4.0 Network Connection Access the Camera through the IP Tool Make sure that the camera and the PC are well connected via LAN. 2. Find the IP-Tool from the CD and then install it in the computer. After that, run the IP Tool as shown below. - Page 9 Sales +44(0)1707 330541 Enquiries sales@genieproducts.co.uk Website www.genieproducts.co.uk...