Camera Performance Specifications - Genie M640 User Manual

Camera Performance Specifications

Specifications for each available sensor are listed after the general Genie camera specifications.
Camera Controls
Synchronization Modes
Exposure Modes
Trigger Input
Strobe Output
Features
LUT
Flip
Binning
Timestamp
Test image
User settings
Optical Interface
Back Focal Distance—C-Mount
Back Focal Distance—CS-Mount
Mechanical Interface
Camera Size
Mass
Power connector
Ethernet connector
Electrical Interface
Input Voltage
Power Dissipation
Operating Temperature
Output Data Configuration
Data and Control
8 • Genie Monochrome Series Overview
Free running and Triggered
Synchronous and Reset mode
Software trigger (through Ethernet)
Programmable (1µs granularity, minimum (see sensor data) – maximum 4s)
Pulse controlled
Opto-isolated, 2V to 12V typical, 2mA min.
Debounce range from 1 µs up to 255 µs
Output opto-isolated: Aligned to the start of exposure with a programmable delay,
duration and polarity
8-bit / 10-bit
Real-time horizontal flip
Horizontal (2 pixel) and Vertical (2 line)
1µs internal timer to timestamp images and events
Internal pattern generator
Select factory default or one user camera configuration
17.52 mm
12.52 mm
29(H) x 44(W) x 67(L) in mm, ( see Mechanical Specifications )
< 125g (no lens)
12 pin male Hirose
RJ45
+11 to +13 Volts DC, ( over voltage–reverse voltage protected )
< 4W
0 to 45°C (at front plate)
Gigabit Ethernet (IEEE 802.3)
GigE Vision compliant at 1000 or 100 Mbps
Genie Monochrome Series-GigE Vision Camera