Additional Notes On Genie Mechanical; Connectors; 12-Pin Hirose Connector Signal Details - Genie M640 User Manual

Additional Notes on Genie Mechanical

Genie supports a screw lock Ethernet cable (see "Ruggedized RJ45 Ethernet
For information on Genie lens requirements see "Optical
Lens flange focal distance = 17.52 mm.
Lens flange focal distance = 12.52 mm for CS-mount.
The camera top also has four mounting holes in identical locations.

Connectors

•
A single RJ45 Ethernet connector for control and video data to the host Gigabit NIC. Genie is available with
an industrial case supporting a screw lock Ethernet cable (see "Ruggedized RJ45 Ethernet
105).
•
A single 12-pin Hirose male connector for power, trigger and strobe signals. The suggested female cable
mating connector is Hirose model HR10A-10P-12S.

12-Pin Hirose Connector Signal Details

The following figure shows the pinout identification when looking at the Genie camera 12-pin male Hirose
connector. The table below the figure lists the Genie I/O signal specifications.
Pin Direction
1 -
2 -
3 Out
4 Out
5 In
6 In
7 Out
8 Out
9 -
10 -
11 In
12 In
Genie Monochrome Series-GigE Vision Camera
Genie Signal (see details below)
Power GND
+12V DC power supply
Output 1 -
Output 1 +
Input 1 -
Input 1 +
Output 2 + / Strobe +
Output 2 - / Strobe -
Reserved
Reserved
Input 2 +
Input 2 -
Cables" on page
Considerations" on page 101.
Notes
10% tolerance
RS422- or TTL GND
RS422+ or TTL
RS422+ or TTL
RS422- or TTL GND
Technical Specifications • 95
105).
Cables" on page