Installation; Installing The Camera - Genie WIPX8VDVAF5 Quick Start Manual

3.0 Installation

3.1 Installing the Camera

Please make sure that the wall or ceiling is strong enough to withstand 3 times the weight
of the camera. Please install the camera in and under a dry environment and place the
cover of the camera within 4 hours of removing it. Do not remove the protection film until
finishing the installation.
1.
2. Attach the drill template to the place where you want to fix the camera and then drill
3. Loosen the screws to open the lower dome.
4. Route and connect these cables. Then secure the camera to the ceiling or wall with the
5. Three-axis adjustment. Before adjustment, preview the image of the camera on a
9
Rotate the trim ring anti-clockwise to remove it from the camera.
4 screw holes and 1 cable hole (if you want to route the cables through the ceiling)
according to the drill template.
Trim Ring
screws provided.
monitor and then adjust the camera according to the figure below to get an optimum
angle.
Rotation 0-345°
Rubber Plug
Install it when routing the
cables through the ceiling.
Lower Dome
Pan 0-345°
Tilt 0-77°
Hold it and rotate