Menu Operation - Furuno FCR-2107 Operator's Manual

1.4

Menu Operation

There are two main menus, radar/chart radar and ECDIS, and the one currently available depends on operating
mode. You can access the main menu from the full keyboard or by using the trackball. In later sections only the
procedure for operation by trackball is given. In the example below the menu operating procedure for operation on
the radar/chart radar main menu is presented.
Main menu
How to enter data
Alphanumeric data can be changed by selecting it with the cursor then pushing the left button. (This action also
displays minimum and maximum values beside the input field.) Spin the scrollwheel to select value then push it to
confirm setting. (Alphanumeric data may also be entered directly from the keyboard-equipped control unit.)
To change a specific alphanumeric character, use the trackball to put the cursor to the left of the digit or character
that you want to change and spin the scrollwheel to select appropriate character.
How to change co-ordinate polarity (available in the ECDIS mode)
By clicking co-ordinate polarity
1. Put the cursor before the co-ordinate (N, S, E, W) then push the left button.
2. Spin the scrollwheel to select desired polarity then push the scrollwheel.
By choosing polarity from drop-down menu
1. Put the cursor inside the input window.
2. Push the right button to show the following menu.
PICTURE dialog box
1. Do one of the following depending on the control
unit you are using.
• Control unit RCU-020: Push the MENU key
to show the Main menu.
• Control unit RCU-015 (or RCU-020): Use the
trackball to select the MENU box at the right
side of the screen then push the left button to
show the Main menu, shown left.
2. Use the trackball to select desired menu then push
the scrollwheel to open the menu selected. For
example, select Picture to show the PICTURE
dialog box, shown left.
3. Use the trackball to put the cursor on the setting of
the item you wish to change. The setting changes
color to indicate it is selected. (The color depends on
the color arrangement in use.)
4. Spin the scrollwheel to select setting desired then
push it or the left button to confirm setting.
5. Push the right button to close the menu. (Several
pushes may be necessary depending on the menu
used. In some cases you will click the Close window
button (X) at the top right corner on the menu.)
Note: Hereafter, for sake of brevity, we state "push the
scrollwheel" in cases where you can push either it or the
left button.
1. Operational Overview
1-5