Safety Instructions - Furuno FE-700 Installation Manual

SAFETY INSTRUCTIONS

The operator and installer must read the applicable safety instructions before attempting to
install or operate the equipment.
WARNING
CAUTION
Warning, Caution
WARNING WARNING
Do not open the equipment unless
totally familiar with electrical circuits
and service manual.
Only qualified personnel should
work inside the equipment.
Turn off the power at the switchboard
before beginning the installation.
Fire or electrical shock can result if the
power is left on.
Do not install the equipment where it
may get wet from rain or water splash.
Water in the equipment can result in fire,
electrical shock or equipment damage.
Be sure no water leaks in at the trans-
ducer mounting location.
Water leakage can sink the vessel. Also
confirm that the transducer will not loosen
by ship's vibration. The installer of the
equipment is solely responsible for the
proper installation of the equipment.
FURUNO will assume no responsibility
for any damage associated with improper
installation.
Be sure that the power supply is
compatible with the voltage rating of
the equipment.
Connection of an incorrect power supply
can cause fire or equipment damage. The
voltage rating of the equipment appears
on the label above the power connector.
Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided,
can result in minor or moderate injury.
Prohibitive Action
Display
unit
Distribution
Box
Matching Box
Transducer
Switch Box
(option)
Junction Box
(option)
Digital depth
indicator (option)
Distribution box
(option)
i
Mandatory Action
CAUTION CAUTION
Observe the following compass safe
distances to prevent deviation of a
magnetic compass:
Standard
compass
0.55 m
1.00 m
0.50 m
1.00 m
0.30 m
0.50 m
0.30 m
When handling the transducer cable,
keep in mind following points:
- Keep the cable away from oil and fuel.
- Keep the cable away from the place
where it may be damaged during the
installation.
- Do not paint the cable.
- The sheath of the transducer cable is
made of chlorophrene rubber (or vinyl
chloride). Therefore, do not paint the
sheath with organic liquid (such as
toluene) since it may harm the sheath.
Steering
compass
0.35 m
0.65 m
0.40 m
0.60 m
0.30 m
0.40 m
0.30 m