Power Requirements - Jacuzzi J - 415 Owner's Manual

J-400
7.0

Power Requirements

Jacuzzi ® spas are designed to provide optimum performance and
flexibility of use when connected to their maximum electrical service.
They are configured at the factory. The most common electrical
connections are listed below:
• All North American 60 Hz Models only: These models come set for
50A logic. If you prefer, your qualified technician can perform a logic
modification that allows the spas to operate on a different electrical
service (see table footnotes below).
North American J-425/J-460/J-465/J-470/J-480 Models (60 Hz)
Voltage:
Max. Current Draw:
Frequency:
Number of Wires:
Circuit Breaker (2-Pole):
In 30A configuration, the heater will not operate while either jets
*
pump is running.
** In 50A configuration, the heater will operate when one jets pump
is running, but will not operate while both jets pumps are running.
This is the factory setting.
*** In 60A configuration the heater will operate while both jets pumps
are running.
Voltage:
Max. Current Draw:
Frequency:
Number of Wires:
Circuit Breaker (2-Pole):
In 40A configuration, the heater will not operate when any jets
*
pump is running.
** In 50A configuration, the heater will operate when one jets pump
is running, but will not operate when two or more jets pumps are
running. This is the factory setting.
*** In 60A configuration the heater will operate when two jets pump
are running, but will not operate when all three jets pumps are
running.
Page 16
240 VAC
60 Hz
North American J-495 Models (60 Hz)
240 VAC
60 Hz
240 VAC
23A 36A
60 Hz
3
30A* 50A**
240 VAC
23A 36A
60 Hz
3
40A* 50A**
240 VAC
45A
60 Hz
3 3
60A***
240 VAC
45A
60 Hz
3 3
60A***