Power Requirements - Jacuzzi J-495 Owner's Manual

J-400
7.0

Power Requirements

Jacuzzi ® spas are designed to provide optimum performance and
flexibility of use when connected to their maximum electrical service.
They are configured at the factory. The most common electrical
connections are listed below:
• All North American 60 Hz Models only: These models come set for
50A logic. If you prefer, your qualified technician can perform a logic
modification that allows the spas to operate on a different electrical
service, see table footnotes below. Reference page 85.
Voltage:
Max. Current Draw:
1-Pump System:
2-Pump System:
3-Pump System:
Frequency:
Number of Wires:
In 40A configuration, the heater will not operate while either jets pump is
*
running. Not recommended for the J495.
In 50A configuration, the heater will operate when one jets pump is
**
running, but will not operate if more than one jets pump is running. This
is the factory setting.
*** In 60A configuration the heater will operate when two jets pumps are
running, but will not operate if three jets pumps is running.
Page 16
North American Models (60 Hz)
240 VAC/40A*
26A
26A
N/A
60 Hz
3
240 VAC/50A**
36A
37A
37A
60 Hz
3
240 VAC/60A***
N/A
48A
48A
60 Hz
3