Programming Instructions For Settings 1 Menus - Jacuzzi J - 415 Owner's Manual

12.0 Programming Instructions for Settings 1 Menus

Your Jacuzzi spa is equipped with three settings menus that allow you to
program and activate different components of the spa. In the "Settings 1"
menu you can program the Heating, the CLEARRAY™ Water Purification
System (UV), and the check/clean filter reminder. You can also access
the "Settings 2" menu (Section 13.0, page 71) and the Filter Boost
function.
Your Jacuzzi spa is equipped with three modes of heating. An energy
saving heating cycle called "Eco-Mode." An automatic mode called
"Auto-Heating", where the spa's temperature is maintained at all times
by the "Setpoint." Lastly a "Programmable" mode, where the spa will only
activate the heater at set times programmed by you. To activate either
mode follow the procedures below.
To access the Settings 1 Menu:
1. Press button D from the Main Menu (page 45) to enter the
Settings 1 Menu (Figure A).
2. From this menu you can choose a heating cycle, set the timer for the
CLEARRAY Water Purification System, and set the change/clean
filter reminder.
A
B
= Heating Menu Icon: Press button A to access the heating
programs.
= Filter boost icon: Press button C to activate the filter boost
cycle. All the jets pumps will activate for 20 minutes for
additional filtering. The display will read "Filter Boost Enabled"
and revert to the "Settings 1" Menu within 5 seconds.
= Settings 2 Menu Icon: Press button B to access the
2
additional programming features.
= Previous Icon: Press button D to return to the previous
menu.
SETTINGS 1
Heating
UV Light
1
Filter
Press
2
set filter or UV timer
0 Days
OFF
to
J-400
C
D
Figure A
Page 65