Table of Contents
Advertisement
Linksys
Connect/ Disconnect:
If the WAN type is PPPoE or PPTP, this button
will appear . Click Disconnect to cut the
connection from ISP server . Click Connect to
re-dial to the server .
DMZ Status:
NOTE:
It is recommended to designate the configurable port on the
LRT224 as a DMZ port . Go to Device Configuration > Network and
check the Enable DMZ box .
IP Address:
IP address of DMZ port .
DMZ Host:
Private IP of DMZ host .
Firewall Settings
This section displays the current firewall settings:
SPI (Stateful Packet Inspection): Default configuration is On .
DoS (Denial of Service):
Block WAN Request:
Remote Management:
Access Rule:
VPN Settings
Tunnel(s) Used:
Number of tunnels configured .
Tunnel(s) Available: Number of tunnels the router supports .
OpenVPN Status
Tunnel(s) Used:
Number of OpenVPN tunnels configured .
Tunnel(s) Available:
Number of OpenVPN tunnels the router supports .
Default configuration is On .
Default configuration is On .
Default configuration is Off .
The number of access rules configured
in the router .
Getting Started with the Router Configuration
Log Setting Status
This section displays the following information:
Syslog Server:
Indicates whether Syslog server is activated .
Email Log:
Indicates whether Email Log is activated .
5
Hide quick links:
Advertisement
Table of Contents
