System Management; Dual Wan (Lrt224 Only) / Network Service Detection; Dual Wan; Network Service Detection - Linksys LRT224 User Manual

Linksys

System Management

You can configure advanced setting in System Management category, please
refer to following items:
• Dual WAN (LRT224 Only) / Network Service Detection
• Bandwidth Management
• Session Control
• SNMP
• SSL Certificate
Dual WAN (LRT224 Only) / Network
Service Detection

Dual WAN

You can choose Link Failover or Load Balance mode when you use the Dual
WAN setting . Go to Configuration > System Management > Dual WAN .
NOTE:
Remember to click Save before leaving the page . You can also click
Cancel to undo the changes .
Mode
You can configure two Internet connections by using the WAN and the WAN/DMZ port .
Two modes can be selected:
Link Failover: Only the primary WAN port works in normal time; the
other WAN is a backup port .
If the primary WAN connection is unavailable, the backup
WAN connection will take over the traffic .
Load Balance: Two WAN ports will work simultaneously . The router will
balance traffic between the two ports .

Network Service Detection

This is a detection system for network external services . If this option is selected,
information such Retry or Retry Timeout will be displayed . If two WANs are
used for external connection, be sure to activate the NSD system, so as to avoid
any unwanted break caused by the device misjudgment of the overload traffic
for the WAN .
System Management
30