Wan Setting/ Dmz Setting (Internet Connection & Dmz) - Linksys LRT224 User Manual

Linksys
NOTE:
A pop-up confirmation message will appear to remind you to log
in to the user Web GUI with the new device IP address. Click OK to
confirm the change, or click Cancel to leave without applying the
changes.
Multiple Subnet Setting (IPv4 only)
This function enables users to add IP segments that differ from the router
network segment to the multi-net segment configuration. The Internet will
then be directly accessible.
Add a VLAN: Click the button to add a new VLAN. The router
supports up to 5 VLANs. In other words, you can
add another 4 new VLANs.
Add a Subnet for 1. Click the button and a pop-up window will
appear.
Outbound NATing:
2. Check "Add Local Subnet" or "Add Adjacent
subnet (where you have another router to reach
this subnet)" to identify the type of subnet.
3. Enter a LAN IP address and a Subnet Mask. The
IP address and subnet mask will appear in the list.
Repeat this step as needed to add more subnets.
4. You can also modify an existing subnet by clicking
the edit icon.
5. Click the trash can icon to delete the subnet.
WAN Setting/ DMZ Setting
(Internet connection & DMZ)
To set the WAN port to link to the Internet, refer to the configuration information
provided by your ISP (Internet Service Provider). The WAN setting table shows
WAN and DMZ ports of the router. You can configure the WAN/DMZ port for
use as a DMZ.
WAN Setting
NOTE:
Remember to click Save before leaving the page. You can also click
Cancel to undo the changes.
Interface:
An indication of which port is connected.
WAN Obtain an IP automatically, Static IP, PPPoE (Point-
to-Point Protocol over Ethernet), PPTP (Point-to-
Connection Type:
Point Tunneling Protocol) and Transparent Bridge.
Config.:
A modification in an advanced configuration. Click
Edit to enter the advanced configuration page.
Setup
9