Table of Contents
Advertisement
Linksys
VPN Passthrough
Enable VPN passthrough to allow VPN clients to pass through the router.
You can also disable the VPN passthrough to block VPN connection. Use the
Device Configuration > VPN > VPN Passthrough page to enable or disable VPN
passthrough.
NOTE:
Remember to click Save before leaving the page. You can also click Cancel to
undo the changes.
IPSec Pass Through: If enabled, IPSec tunnel is allowed to pass through the
router.
PPTP Pass Through: If enabled, PPTP is allowed to pass through the router.
L2TP Pass Through: If enabled, L2TP is allowed to pass through the router.
PPTP Server
Use the Configuration > VPN > PPTP Server page to enable PPTP (Point-to-
Point Tunneling Protocol) VPN tunnels for users who are running PPTP client
software on Microsoft Windows.
NOTE:
Remember to click Save before leaving the page. You can also click Cancel to
leave without any change.
Check the Enable PPTP Server box to allow PPTP VPN tunnels. Uncheck the
box to disable this feature. It is disabled by default.
IP Address Range
Range Start:
Enter the first address of LAN range to assign to the PPTP
VPN clients.
Range End:
Enter the final address of LAN range to assign to the PPTP
VPN clients.
The default range is 192.168.1.200 to 92.168.1.204. The LAN IP address range
for PPTP VPN clients should be outside of the normal DHCP range of the router.
PPTP Server
Add or edit the list of PPTP VPN users.
VPN
58
Hide quick links:
Advertisement
Table of Contents
