Table of Contents
Advertisement
Linksys
SMTP Port:
Username:
Password:
IPv6 Transition
When Dual-Stack IP is enabled on the Setup > Network page, a 6to4 tunnel
is enabled by default for IPv6 packets via 6to4 source/destination addressing
exchange. This feature allows the router to establish auto-tunnel in IPv4
network (or a real IPv4 Internet connection) across two independent IPv6
networks. Use the Setup > IPv6 Transition page to disable or enable this
feature.
IPv6 Transition establishes a 6to4 tunnel that enables two IPv6 networks to
communicate through IPv4 infrastructure. When you enable dual-stack IP, IPv6
transition will be turned on by default.
Check the box to enable the 6to4 tunnel, or uncheck the box to disable.
You have to enable Managed RA flags to support auto-configuration to get
the 6to4 prefixes (Please refer to Router Advertisement), such as 2002:[IPv4
WAN IP in hex number]::.
NOTE Remember to click Save before leaving the page. You can also click
Cancel to undo the changes.
1~65535 can be accepted. The
default value is 25.
Username for authentication.
Password for authentication.
Setup
24
Hide quick links:
Advertisement
Table of Contents
