Linear Amplifier Connections - Icom IC-7000 Instruction Manual

2
INSTALLATION AND CONNECTIONS
■ Linear amplifier connections
CONNECTING THE IC-PW1/EURO
To an
antenna ACC-1
ANT
AC outlet
(
Non-European versions : 100–120/220–240 V
European version
CONNECTING A NON-ICOM LINEAR AMPLIFIER
R WARNING:
• Set the transceiver output power and linear ampli-
fier ALC output level referring to the linear ampli-
fier instruction manual. Be sure the linear ampli-
fier keying circuit control voltage is compatible
with the IC-7000, before connecting to HSEND
line (ACC cable).
• The ALC input level must be in the range 0 V to
–4 V, and the transceiver does not accept positive
voltage. Non-matched ALC and RF power settings
could cause a fire or damage the linear amplifier.
To an
antenna
RF OUT
21
Remote control cable
ACC cable
(supplied with the IC-PW1/EURO)
REMOTE
EXCITER
1 1&2
IC-PW1/EURO
: 230 V
50 coaxial cable
RF IN
ALC
KEY
Relay
Use the [ANT1] connector when connecting an HF/50
MHz linear amplifier.
(supplied with the IC-PW1/EURO)
OPC-599 conversion cable
INPUT1
Coaxial cable
(supplied with the IC-PW1/EURO)
GND
Ground
)
• The IC-7000 SEND relay is rated at 16 V and a
0.5 A DC. If these levels are exceeded, a larger
external relay must be used.
ALC (Blue)
HSEND
(Orange)
13.8V (Gray)
7-pin side
ACC REMOTE
Transceiver
ANT1
Transceiver
ACC
ACC cable
GND
ANT1
GND
Ground