Memory Module - HP ENVY 14 Maintenance And Service Manual

Memory module

Description
4 GB memory module (PC3, 12800, 1600 MHz)
8 GB memory module (PC3, 12800, 1600 MHz)
NOTE: Before adding memory modules, make sure the computer has the most recent BIOS
version, and update the BIOS if needed. For Windows operating systems, see
on page 66; for Ubuntu Linux, see
Diagnostics on page
Before removing a memory module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Optical drive (see
b. Top cover (see
c. Power connector cable (see
d. System board (see
Remove the memory module, located on the bottom of the system board:
NOTE: Note the location of the memory module you are removing. If you are replacing it, install the
new memory module in the same slot.
1. Spread the two retaining tabs (1) on each side of the memory module slot to release
the memory module. (The memory module tilts up.)
52 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Ubuntu Linux – Using Setup Utility (BIOS) and System
69.
Battery on page
Optical drive on page
Top cover on page
Power connector cable on page
System board on page
29), and then remove the following components:
29)
37)
48)
Spare part number
691740-005
693374-005
Updating the BIOS
58)