Fan - HP ENVY 14 Maintenance And Service Manual

2. Remove the memory module (2) by pulling it away from the slot at a 45 degree angle.
Reverse this procedure to install the memory module.

Fan

Description
Fan
NOTE: To properly ventilate the computer, allow at least 7.6 cm (3 in) of clearance on the left side
of the computer. The computer uses an electric fan for ventilation. The fan is controlled by a
temperature sensor and is designed to turn on automatically when high temperature conditions exist.
These conditions are affected by high external temperatures, system power consumption, power
management/battery conservation configurations, battery fast charging, and software requirements.
Exhaust air is displaced through the ventilation grill located on the left side of the computer.
Before removing the fan, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Optical drive (see
b. Top cover (see
c. Power connector cable (see
d. System board (see
Battery on page 29), and then remove the following components:
Optical drive on page
Top cover on page 37)
Power connector cable on page
System board on page
29)
58)
48)
Component replacement procedures
Spare part number
763700-001
53