Hard Drive - HP ENVY 14 Maintenance And Service Manual

Hard drive

NOTE: The hard drive spare part kit does not include the hard drive rubber bracket, hard drive
connector cable, or screws. These components are included in the Hard Drive Hardware Kit, spare
part number 767247-001.
Description
500 GB, 5400 rpm, 9.5 mm
750 GB, 5400 rpm, 9.5 mm
1 TB, 5400 rpm, 9.5 mm
1.5 TB, 5400 rpm, 9.5 mm
1 TB, 5400 rpm + 8 GB NAND hybrid, 9.5 mm
750 GB 5400 rpm + 8 GB NAND hybrid, 9.5 mm
Before removing the hard drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Optical drive (see
b. Top cover (see
Remove the hard drive:
1. Disconnect the USB/audio cable (1) by flipping open the connector and lifting the cable. Lift up
front of the USB/audio board (2), and then remove the USB/audio board (3). The USB/audio
board spare part number is 767370-001.
Battery on page 29), and then remove the following components:
Optical drive on page
Top cover on page 37)
29)
Component replacement procedures
Spare part number
778188-005
778190-005
778192-005
747375-005
731999-005
732001-005
41