Displaying System Information; Restoring Factory Default Settings In Setup Utility; Exiting Setup Utility; Using System Diagnostics - HP ENVY 14 Maintenance And Service Manual

Displaying system information

1. Start Setup Utility.
2. Select the Main menu. System information such as the system time and date, and identification
information about the computer is displayed.
3. To exit Setup Utility without changing any settings, use the arrow keys to select Exit > Exit
Discarding Changes, and then press enter.

Restoring factory default settings in Setup Utility

1. Start Setup Utility.
2. Use the arrow keys to select Exit > Load Setup Defaults, and then press enter.
3. When the Setup Confirmation is displayed, press enter.
4. To save your change and exit Setup Utility, use the arrow keys to select Exit > Exit Saving
Changes, and then press enter.
The Setup Utility factory settings take effect when the computer restarts.
NOTE: Your password, security, and language settings are not changed when you restore the
factory settings.

Exiting Setup Utility

To exit Setup Utility and save your changes from the current session:
●
If the Setup Utility menus are not visible, press
arrow keys to select Exit > Exit Saving Changes, and then press enter.
To exit Setup Utility without saving your changes from the current session:
●
If the Setup Utility menus are not visible, press
arrow keys to select Exit > Exit Discarding Changes, and then press enter.

Using System Diagnostics

System Diagnostics allows you to run diagnostic tests to determine if the computer hardware is
functioning properly.
To start System Diagnostics:
1. Turn on or restart the computer. While the "Press the ESC key for Startup Menu" message is
displayed in the lower-left corner of the screen, press esc. When the Startup Menu is displayed,
press f2.
2. Click the diagnostic test you want to run, and then follow the on-screen instructions.
NOTE: If you need to stop a diagnostics test while it is running, press esc.
70 Chapter 8 Ubuntu Linux – Using Setup Utility (BIOS) and System Diagnostics
esc to return to the menu display. Then use the
esc to return to the menu display. Then use the