Display Assembly - HP ENVY 14 Maintenance And Service Manual

Display assembly

This section describes removing the display assembly in its entirety and disassembling all the display
subcomponents.
If you only need to remove the display bezel, webcamera/microphone module, or display panel, you
do not need to remove the entire display assembly from the computer. See Display subcomponents
(bezel, webcam, panel) on page 34 for more information about removing the display subcomponents
that do not require that you remove the entire display assembly from the computer.
Description
Raw display panel, 14.0 in (35.56 cm), high definition (HD), WLED, SVA BrightView flat display
assembly
Raw display panel, 14.0 in (35.56 cm), full high definition (FHD), WLED, SVA Antiglare slim
display assembly
Antennas
Display bezel
Display cable
Display cable, FHD
Display enclosure
Hinge
Webcamera/microphone module
Before removing the display assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Optical drive (see
b. Top cover (see
Remove the display assembly:
1. Disconnect the display cable (1) by flipping open the connector and lifting the cable.
2. Release the wireless antenna cables from the clips (2) built into the base enclosure.
3. Remove the three Phillips PM2.5×4.0 screws (3) that secure the display assembly to
the base enclosure.
Battery on page 29), and then remove the following components:
Optical drive on page
Top cover on page 37)
29)
Component replacement procedures
Spare part number
763566-001
767373-00
767237-001
767365-001
767244-001
767366-001
763751-001
767248-001
762521-001
61