IBM IntelliStation M Pro 6233 Hardware Maintenance Manual page 72

3. Continue with step 1 of "Second microprocessor installation."
Second microprocessor installation
To install a second microprocessor, do the following:
Attention:
damage from static electricity. For details on handling these devices, refer to
"Handling static-sensitive devices" on page 43.
10. Rotate the locking lever on the microprocessor socket from its closed and
62
Hardware Maintenance Manual: IBM IntelliStation M Pro Type 6233 and 6850
g. On the next window, click the Display a known list of drivers for this
device so that I can choose a specific driver radio button; then, click
Next.
h. On the next window, click the Show all hardware of this device class
radio button. Under the Models field, select ACPI Multiprocessor PC; then,
click Next.
i. If the configuration shown in the wizard is satisfactory, click Next to save the
configuration.
j. Click Finish to complete the process.
k. When prompted as to whether you want to restart the computer, select Yes.
When you handle static-sensitive devices, take precautions to avoid
1. Read the instructions that come with the new microprocessor.
2. Turn off the computer and all attached devices.
3. Disconnect all external cables and power cords from the computer and remove
the computer cover (see "Removing the cover and front bezel" on page 47).
4. Lay the computer on its side for better access to the computer components.
5. Remove the memory board.
6. If the computer has an air baffle, remove it (see "Removing the air baffle" on
page 48).
7. See the system board label inside the computer for the location of the second
microprocessor socket (CPU).
8. Remove the screws from the plastic microprocessor cover; then, remove the
plastic microprocessor cover (keep the cover for future use).
Note: Some models have the plastic microprocessor cover attached to the air
baffle. If this is the case, you must remove the air baffle and
microprocessor together, after removing the screws for the plastic
microprocessor cover.
9. Touch the static-protective package containing the microprocessor to any
unpainted metal surface on the computer. Then, remove the microprocessor
from the package.
locked position until it stops or clicks in the fully open position (approximately
135° angle), as shown. Then, see the documentation provided with the
microprocessor option for complete installation instructions.
Attention: You must ensure that the locking lever on the microprocessor
socket is in the fully open position before you insert the microprocessor in the
socket. Failure to do so might result in permanent damage to the
microprocessor, microprocessor socket, and system board.