Table of Contents
Advertisement
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water.
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
For further information on battery disposal, call IBM at 1-800-IBM-4333
(1-800-426-4333) in the U.S. For information outside of the U.S., contact an IBM
reseller or marketing representative.
To change the battery, do the following:
30
Hardware Maintenance Manual: IBM IntelliStation M Pro Type 6233 and 6850
1. Turn off the computer and all attached devices.
2. Unplug the power cord.
3. Remove the cover. See "Removing the cover and front bezel" on page 47.
4. Disconnect the hard disk drive power cable and the hard disk drive fan cable
on the memory board.
5. Push the tab on the back of the memory board inward and pull the memory
board out of the chassis.
Note: If any long adapters are installed in PCI slots, they must also be
removed. These adapters must also be replaced before replacing the
memory board.
6. Locate the battery. Refer to the system board label inside the computer.
7. Remove the old battery.
8. Install the new battery.
Advertisement
Table of Contents
