Table of Contents
Advertisement
4. Use the arrow keys to select a choice from the menu.
5. Follow the instructions on the screen to change the settings of the selected
SCSISelect menu choices
The following choices appear on the SCSISelect Utility menu:
Configure/View Host Adapter Settings
Advanced Configuration Options
v Press Esc to exit the SCSISelect Utility program.
v Press the F5 key to switch between color and monochrome modes (if the
monitor permits).
items; then, press Enter.
Select this choice to view or change the SCSI controller settings. To reset
the SCSI controller to its default values, press F6; then, follow the
on-screen instructions.
You can view or change the following controller settings:
v Host Adapter SCSI ID
Select this choice to view the SCSI controller identification (ID), which is
usually 7.
v SCSI Parity Checking
Select this choice to view the assigned value of Enabled.
v Host Adapter SCSI Termination
Select this choice to view the assigned value of Automatic.
v Boot Device Options
Select this choice to configure startable-device parameters. Before you
can make updates, you must know the ID of the device whose
parameters you want to configure.
v SCSI Device Configuration
Select this choice to configure SCSI-device parameters. Before you can
make updates, you must know the ID of the device whose parameters
you want to configure.
Note: The Maximum Sync Transfer Rate represents the transfer rate for
Ultra SCSI devices.
– The transfer rate for Ultra160 low voltage differential (LVD)
devices is 160.0 MBps.
– The transfer rate for Ultra2 SCSI LVD devices is 80.0 MBps.
– The transfer rate for Fast SCSI devices is 20.0 MBps.
Select this choice to view or change the settings for advanced configuration
options. These options include enabling support for large hard disk drives
and support for drives with Ultra SCSI speeds.
37
Configuration
Advertisement
Table of Contents
