Introduction To Arp - 3Com 4210 PWR Configuration Manual

23

Introduction to ARP

ARP Function
ARP Message Format
ARP C
Address Resolution Protocol (ARP) is used to resolve an IP address into a data link
layer address.
An IP address is the address of a host at the network layer. To send a network layer
packet to a destination host, the device must know the data link layer address
(MAC address, for example) of the destination host or the next hop. To this end,
the IP address must be resolved into the corresponding data link layer address.
n
Unless otherwise stated, a data link layer address in this chapter refers to a 48-bit
Ethernet MAC address.
ARP messages are classified as ARP request messages and ARP reply messages.
Figure 84 illustrates the format of these two types of ARP messages.
As for an ARP request, all the fields except the hardware address of the receiver
■
field are set. The hardware address of the receiver is what the sender requests
for.
As for an ARP reply, all the fields are set.
■
Figure 84 ARP message format
Length of hardware address Length of protocol address Length of hardware address Length of protocol address
Hardware address of the receiver Hardware address of the receiver
Table 210 describes the fields of an ARP packet.
ONFIGURATION
Hardware type (16 bits) Hardware type (16 bits) Hardware type (16 bits)
Protocol type (16 bits) Protocol type (16 bits)
Operator (16 bits) Operator (16 bits)
Hardware address of the sender Hardware address of the sender
IP address of the sender IP address of the sender
IP address of the receiver IP address of the receiver