3Com 4210 PWR Configuration Manual page 227

Timer and Maximum
User Number
Configuration
n
from them in handshaking periods. To prevent users being falsely considered
offline, you need to disable the online user handshaking function in this case.
For the handshaking packet secure function to take effect, the clients that
■
enable the function need to cooperate with the authentication server. If either
the clients or the authentication server does not support the function, disabling
the handshaking packet secure function is needed.
Table 163 Configure 802.1x timers and the maximum number of users
Operation Command
Enter system view system-view
Set the In system dot1x max-user user-number [
maximum view interface interface-list ]
number of
In port interface interface-type
concurren
view interface-number
t on-line
users for dot1x max-user user-number
specified
quit
ports
Set the maximum retry dot1x retry max-retry-value
times to send request
packets
Set 802.1x timers dot1x timer {
handshake-period
handshake-period-value |
quiet-period quiet-period-value
| server-timeout
server-timeout-value |
supp-timeout
supp-timeout-value | tx-period
tx-period-value | ver-period
ver-period-value }
Enable the dot1x quiet-period
quiet-period timer
As for the dot1x max-user command, if you execute it in system view without
■
specifying the interface-list argument, the command applies to all ports. You
can also use this command in port view. In this case, this command applies to
the current port only and the interface-list argument is not needed.
Basic 802.1x Configuration
Remarks
-
Optional
By default, a port can
accommodate up to 256 users at
a time.
Optional
By default, the maximum retry
times to send a request packet is
2. That is, the authenticator
system sends a request packet to
a supplicant system for up to two
times by default.
Optional
The settings of 802.1x timers are
as follows.
handshake-period-value:
■
15 seconds
quiet-period-value: 60
■
seconds
server-timeout-value: 100
■
seconds
supp-timeout-value: 30
■
seconds
tx-period-value: 30
■
seconds
ver-period-value: 30
■
seconds
Optional
By default, the quiet-period timer
is disabled.
225