3Com 4210 PWR Configuration Manual page 94

9/18/26 port and pwr 9/18/26 port 4210 series switch
Table of Contents

Advertisement

92
C
8: IP P
HAPTER
ERFORMANCE
Disabling ICMP to Send
Error Packets
C
ONFIGURATION
the system restarts the timer from receiving the last non-FIN packet. The
connection is broken after the timer expires.
Size of TCP receive/send buffer
Table 52 Configure TCP attributes
Operation
Enter system view
Configure TCP synwait timer's
timeout value
Configure TCP finwait timer's
timeout value
Configure the size of TCP
receive/send buffer
Sending error packets is a major function of ICMP protocol. In case of network
abnormalities, ICMP packets are usually sent by the network or transport layer
protocols to notify corresponding devices so as to facilitate control and
management.
By default, Switch 4210 Family support sending ICMP redirect and destination
unreachable packets.
Although sending ICMP error packets facilitate control and management, it still
has the following disadvantages:
Sending a lot of ICMP packets will increase network traffic.
If receiving a lot of malicious packets that cause it to send ICMP error packets,
the device's performance will be reduced.
As the ICMP redirection function increases the routing table size of a host, the
host's performance will be reduced if its routing table becomes very large.
If a host sends malicious ICMP destination unreachable packets, end users may
be affected.
You can disable the device from sending such ICMP error packets for reducing
network traffic and preventing malicious attacks.
Table 53 Disable sending ICMP error packets
Operation
Enter system view
Disable sending ICMP
redirects
Disable sending ICMP
destination unreachable
packets
Command
system-view
tcp timer syn-timeout
time-value
tcp timer fin-timeout
time-value
tcp window window-size
Command
system-view
undo icmp redirect send
undo icmp unreach send
Remarks
-
Optional
By default, the timeout value
is 75 seconds.
Optional
By default, the timeout value
is 675 seconds.
Optional
By default, the buffer is 8
kilobytes.
Remarks
-
Required
Enabled by default
Required
Enabled by default

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents