BMW M5 Owner's Handbook Manual page 65

5. Depending on the equipment specification,
select "Change limit:" or the speed value
and press the controller.
6. Turn the controller to adjust the limit. You
may need to overcome a slight resistance if
you wish to enter a relatively high differ-
ence.
7. Press the controller to adopt the setting.
The limit is automatically switched on.
Memorising actual speed as limit value
Select "Accept current speed" and press the
controller. The actual speed is memorised as
the limit value.
Activating limit
Select "On" and press the controller.
The limit is automatically switched on.
Stopwatch
iDrive, operating principle, see page 14.
1. Call up start menu.
2. Call up "Navigation".
On cars without navigation system: call up
"OBC".
3. Select "On-board Info" and press the con-
troller.
4. Select "Stopwatch" and press the control-
ler.
Starting, stopping or resetting
> Select "Start" and press the controller. The
stopwatch starts at the time displayed.
64
Online Edition for Part-No. 01 41 0 159 168 © 03/05 BMW AG
> Select "Reset" and press the controller.
The stopwatch is reset and starts again if it
was running previously.
> Select "Stop" and press the controller.
Timekeeping is stopped.
Taking an intermediate time reading
Select "Interm. time" and press the controller.
The intermediate reading is displayed below
the current time display.
You can also call up other functions at any
time while the stopwatch is running. The
stopwatch continues to run in the back-
ground.<
Settings on the control
display
1. Press the button.
The start menu is called up.
2. Press the controller to call up the menu.
3. Select "Display settings" and press the
controller.
Brightness of the control display
The brightness is automatically adjusted to
ambient light conditions. However, you can
adjust the basic setting.