BMW M5 Owner's Handbook Manual page 38

> "Comfort" program: one LED
> "Normal" program: two LED
> "Sport" program: three LED
To switch off: press button for longer.
You can also activate your preferred program
for active backrest width adjustment of the
driver's seat via the button on the steering
wheel, see MDrive on page 43.
Easy entry/exit*
To facilitate entry and exit, the backrest width is
temporarily opened fully.
Seat, mirror and steering
wheel position memory
You can memorise and call up two different
positions for the driver's and front passenger's
*
seat , the outside mirrors and the steering
wheel.
The lumbar support setting is not stored in the
position memory.
Memorising
1. Turn the ignition key to position 1 or 2, see
page 47.
2. Select the desired seat, outside mirror and
steering wheel positions.
3. Press the button:
The LED in the button comes on.
4. Press the desired memory button 1 or 2:
The LED goes out.
Online Edition for Part-No. 01 41 0 159 168 © 03/05 BMW AG
Calling up
Do not call up the memory while the car is
in motion, otherwise an unexpected seat
or steering wheel movement may cause an
accident.<
Convenience function
1. Open the driver's door after unlocking it, or
turn the ignition key to position 1.
2. Briefly press memory button 1 or 2 as
desired.
The positioning movement is interrupted
immediately if you briefly press a seat
adjustment switch or one of the memory
buttons.
Safety function
1. Close the driver's door and turn the ignition
key to position 0 or 2.
2. Press memory button 1 or 2 as desired until
the adjusting procedure has been com-
pleted.
If the button was pressed accidentally:
press the button again; the LED will go out.
Position memorised in the key
The driver's seat, outside mirror and steering
wheel position that you have selected is memo-
rised in the remote control currently in use.
You can choose when the position is called up:
> Calling up when unlocking the car
> Calling up when opening the driver's door
iDrive, operating principle, see page 14.
1. Call up start menu
2. Press the controller to call up the menu.
3. Select "Vehicle settings" and press the
controller.
4. Select "Door locks" and press the control-
ler.
5. Select "Central locking" and press the con-
troller.
6. Select "Last seat pos." and press the
controller.
37