Cradlepoint IBR600 Product Manual page 96

COR | USER MANUAL Firmware ver. 5.0.0
CRADLEPOINT
6.8.1 Local IP Networks
Local IP Networks displays the following information for each network:
• Network Name and IP address/Netmask (along the top bar)
• Enabled (Yes/No)
• Multicast Proxy (Enabled/Disabled)
• DHCP Server (Enabled/Disabled)
• Schedule (Enabled/Disabled – See the
Schedule tab in the Local Network
Editor)
• VRRP Failover State (Disabled,
Backup, or Master)
• IPv4 Routing Mode (NAT, Standard,
IP Passthrough, Hotspot, Disabled)
• IPv6 Addressing Mode (SLAAC Only,
SLAAC with DHCP, Disable SLAAC
and DHCP)
• Access Control (Admin Access, UPnP Gateway, LAN Isolation)
• Attached Interfaces (Ethernet ports, WiFi, VLAN)
Click Add to configure a new network, or select an existing network and click Edit to view configuration options.
HotSpot (Captive Portal)
When you set a network as a "Hotspot" under Routing Mode, you will also need to:
1) Configure hotspot settings under System Settings → Hotspot Services. This is where you can configure a
"Terms of Service" agreement or select a website for redirection, for example. Click on Configure to link to the
Hotspot Services page.
2) If you want a hotspot that includes WiFi, first set one of your WiFi interfaces to "Open" for its Security Mode and
attach this interface to your hotspot network. Otherwise guests will need to know the password to connect to the
WiFi network even before viewing a Terms of Service page (or other hotspot options).
Finally, make sure your WiFi interface is "Enabled".
© 2013 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 93