Cradlepoint IBR600 Product Manual page 125

COR | USER MANUAL Firmware ver. 5.0.0
CRADLEPOINT
Use ports and/or IP addresses to define the type(s) of traffic attached to this rule. Leaving any field blank will match all
values; all fields are optional.
Source Port(s) and/or Destination Port(s): Enter a port
number between 1 and 65535. To enter a single port
number, input the number into the left box. To enter a range
of ports, fill in both boxes separated by the colon. For
example "80:90" would represent all ports between 80 and
90 including 80 and 90 themselves.
Source IP Address, Source Netmask, Destination IP
Address, and Destination Netmask: Specify an IP address
or range of IP addresses by combining an IP address with a
netmask for either "source" or "destination" (or both). Source
vs. destination is defined by traffic flow. Leave these blank
to include all IP addresses (such as if your rule is defined by
a particular port instead).
EXAMPLE: If you want to associate this rule with your guest LAN,
you could input the IP address and netmask for the guest LAN
here (leaving the last slot "0" to allow for any user attached to the
guest network):
Source IP Address: 192.168.10.0
•
Source Netmask: 255.255.255.0
•
DSCP (DiffServ): Differentiated Services Code Point (DSCP) is the successor to TOS (Type of Service). Use this field to
select traffic based on the DSCP header in each IP packet. This field is sometimes set by latency sensitive equipment
such as VoIP phones.
This setting is optional. For more information see the
DSCP Negate: When checked this rule will match on any packet that does not match the DSCP field.
Click Finish to save this rule.
© 2013 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/
Differentiated services Wikipedia page.
FOR MORE HELP AND RESOURCES PAGE 122