Cradlepoint IBR600 Product Manual page 162

COR | USER MANUAL Firmware ver. 5.0.0
CRADLEPOINT
Tunnel Enabled: Select to activate the tunnel.
Keep Alive: This feature monitors the status of a tunnel. This will more accurately determine if the tunnel is alive or not.
Choose the Rate in seconds for each check (Default: 10 seconds. Range: 2 – 3600 seconds) and the number of Retry
attempts (Default: 3. Range: 1 – 255).
Page 2: Routes
Adding routes allows you to configure what types of
network traffic from the local host or hosts will be allowed
through the tunnel.
Click Add Route to configure a new route. You will need
to input the following information, defined by the remote
network:
• Network Address
• Netmask: (Default: 255.255.255.0)
You can set the tunnel to connect to a range of IP
addresses or to a single IP address. For example, you
could input 192.168.0.0 and 255.255.255.0 to connect
your tunnel to all the addresses of the remote network in
the 192.168.0.x range. Alternatively, you could select a
single address by inputting that address along with a
Netmask of 255.255.255.255.
Click Save to record each new route.
When you have finished adding routes, click Finish to save your GRE tunnel configuration.
© 2013 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 159