Displaying Logs; Figure 265 Displaying Log Categories Example; Figure 266 Displaying Log Parameters Example - ZyXEL Communications Prestige 2602R Series User Manual

Prestige 2602R Series User's Guide
2 Use
sys logs category

Figure 265 Displaying Log Categories Example

Copyright (c) 1994 - 2005 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys
wan
ppp
lan
ras>
3 Use
sys logs category
available for the category.

Figure 266 Displaying Log Parameters Example

ras> sys logs category access
Usage: [0:none/1:log/2:alert/3:both]
ras>
4 Use
sys logs category
record.
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to
record only alerts for that category, and 3 to record both logs and alerts for that category.
Not every parameter is available with every category.
5 Use the
in order to record logs).

Displaying Logs

• Use the
• Use the
log categories.
• Use the
individual Prestige log category.
• Use the
436
to view a list of the log categories.
exit
poe
bridge
dsp
followed by a log category to display the parameters that are
followed by a log category and a parameter to decide what to
command to store the settings in the Prestige (you must do this
sys logs save
command to show all of the logs in the Prestige's log.
sys logs display
sys logs category
sys logs display [log category]
command to erase all of the Prestige's logs.
sys logs clear
device ether
config ip
hdap bm
voice
display command to show the log settings for all of the
command to show the logs in an
Appendix K Log Descriptions